10-15-2019, 11:47 AM
1
Which two options are benefits of EIGRP OTP? (Choose two.)
- A. It fully supports multicast traffic.
- B. It allows EIGRP routers to peer across a service provider without the service provider involvement.
- C. It requires only minimal support from the service provider.
- D. It allows the customer EIGRP domain to remain contiguous.
- E. It allows the administrator to use different autonomous system numbers per EIGRP domain.
- F. It allows EIGRP neighbors to be discovered dynamically.
- A. When OSPF traffic is redistributed into BGP, internal and external routes are redistributed.
- B. When BGP traffic is redistributed into OSPF, the metric is set to 1 unless the metric is defined.
- C. When EIGRP routes on a CE are redistributed through a PE into BGP, the Cost Community POI is set automatically.
- D. iBGP routes automatically redistribute into the IGP if the routes are in the routing table.
- E. When BGP traffic is redistributed into OSPF, eBGP and iBGP routes are advertised.
- F. When EIGRP traffic is redistributed into BGP, a default metric is required.
- A. area 1 - area 0 - MPLS VPN backbone - area 0 - area 2
- B. area 1 - MPLS VPN backbone - area2
- C. area 1 - MPLS VPN backbone - area 1
- D. area 2 - area 0 - MPLS VPN backbone - area 1
- E. area 0- area 2 - MPLS VPN superbackbone - area 1
- A. Both inbound and outbound route filtering can be implemented on a single interface.
- B. A route with a metric of 15 is advertised as unreachable.
- C. RIPng can support as many as 8 equal-cost routes.
- D. 16 is the maximum metric it can advertise.
- E. RIPng can support as many as 32 equal-cost routes
- A. Disable it when you want to send routes that are learned from another routing protocol to peer on the same interface.
- B. Disable it when you want to provide additional backup paths in your network.
- C. It is never advisable to disable split horizon on an EIGRP interface.
- D. Disable it when you need to send updates to peers on the interface on which the updates were received.
- A. It uses ICMP redirects to advertise next-hop addresses to foreign hosts.
- B. It removes address-resolution restrictions, allowing dynamic protocols to advertise routing information for the device loopback address.
- C. It uses a proxy mechanism to allow a device to respond to ARP requests for the addresses of other devices.
- D. It removes address-resolution restrictions, allowing dynamic protocols to advertise routing information for the next-hop address.
- E. It uses a series of ICMP echo messages to relay next-hop addresses.